Siemens HiPath 1120 Programming Manual

Programming an extension
71
Step by step
e
= DTMF prior to ringing
f = DTMF during ringing
g = FSK before ringing (Default for Korea)
h = FSK during ringing
i = FSK prior to ringing or during a conversation
(default for France)
j = FSK during ringing or a conversation
p w Enter the next analog extension number.
or
r w Press this key.
Initial status for programming mode.
Hide group prefix
This settings allows an extension to receive an external
call over an external line belonging to a group of external
lines, and to hide the group number so it does not show
on the display. When a special access call is received
and transferred to an extension with this feature is acti-
vated, the external line number does not show on the
display.
Example: An analog extension receives an external call
over an external line that belongs to group 890 - number
24987049. When this feature is activated, the display
show only 24987049. When this feature is deactivated,
the display shows 89024987049, that is, the number for
the group of external lines followed by the external
number.
Required: Programming mode must be activated (*95
31994).
ell w Enter the programming code.
p w Enter the analog extension number (e.g., 12/102).
q or r w To activate/deactivate external CFW:
q = Activated
r = Deactivated (default)
If the country set (code 165 Æ page 20) is France,
the CLIP FSK feature will be available for the Hi-
Path 1120 only.

Siemens HiPath 1120 Specifications

General

Brand	Siemens
Model	HiPath 1120
Category	Telephone
Language	English