Step by step
Programming an extension
64
Time in a UCD queue
This setting specifies the maximum length of time a call
is allowed to remain in a UCD queue.
Once the time expires, the call is disconnected or for-
warded to a UCD overflow call extension. The default
setting for a call to remain in a queue is 1 minute.
Required: Programming mode must be activated (*95
31994).
dge w Enter the programming code.
p w Enter the UCD subscriber group number (790 to 799).
dd . mm w Enter the time allowed for a call to remain in a queue (00
to 99 in cycles of 5 seconds) where 00 = 0 seconds...
06 = 30 seconds... 12 = 1 minute (default), 99 = 8 min-
utes, 15 seconds.
p w Enter the next UCD subscriber group number.
or
r w Press this key.
Initial status for programming mode.
Waiting message before signaling a UCD call
This feature allows you to connect a call waiting mes-
sage for incoming calls before they ring at a UCD exten-
sion.
Required: Programming mode must be activated (*95
31994).
dgf w Enter the programming code.
p w Enter the UCD subscriber group number (790 to 799).
q or r w Activate/Disable call waiting message:
q = Activated
r = Deactivated (default)
p w Enter the next UCD subscriber group number.
or
r w Press this key.
Initial status for programming mode.
To Next Page
Loading...
