Step by step
General settings
102
Types of caller lists
This setting specifies whether only external calls or all
internal and external calls should be displayed in the
Caller lists.
Required: Programming mode must be activated (*95
31994).
dhm w Enter the programming code.
e or f w Select the type of Caller List:
e = External
f = Internal and external (default)
w Initial status for programming mode.
Deleting digits from the caller list
To insert an interdigit pause you must enter the
"P" character using the HP 1100 Manager or
pressing the Redial Key using a system tele-
phone.
Each "P" character inserts a 2-second pause (de-
fault) in the connection. A longer pause can be in-
serted by entering more than one character (for
example, for a 4-second pause enter "PP")
The first "P#" or "#" specifies that the next digits
for A will only be forwarded if:
1) digital line or S
0
extension :
P# - DTMF digits are sent after local carrier iden-
tification, when B is not answered.
# - DTMF digits are sent after B is answered.
2) Analog trunk or analog extension :
P# or # - DTMF digits are sent after B is an-
swered.
Other characters ("#" and/or "*") may be
added following "P#".
An inter-digit pause("P") cannot be inserted when
using an analog telephone for programming Indi-
vidual speed dialing.
To Next Page
Loading...
