Siemens HiPath 1120 - Message Mode; Message for MSN; System Number

Step by step
EVM module
174
Message mode
This setting specifies whether a message will be played
only once or repeatedly.
Required: Programming mode must be activated (*95
31994).
fdm w Enter the programming code.
e or f Select a Message:
e = Greeting 1
f = Greeting 2
e or f Select the mode:
e = Continuous (default)
f = Single
r w Press this key.
Initial status for programming mode.
Message for MSN
This setting specifies whether a message will be played
for a specific MSN.
Required: Programming mode must be activated (*95
31994).
fed w Enter the programming code.
dde ... ehd w Enter MSN slot (001 ... 140).
e or f Select a Message:
e = Greeting 1
f = Greeting 2
r w Press this key.
Initial status for programming mode.
System number
This setting specifies the HiPath 1100 number to be
used when the system operates in a Point-to-Point (PP)
environment.
Required: Programming mode must be activated (*95
31994).