Siemens HiPath 1120 - Activating a Software Update; Day for SW Update

General settings
109
Step by step
djd
w Enter the programming code.
w Initial status for programming mode.
Activating a software update
This feature allows you to update the system’s software
automatically over an ISDN network on a scheduled
date.
Required: Programming mode must be activated (*95
31994).
dii w Enter the programming code.
q or r w Activate/deactivate software update:
q = Activated
r = Deactivated (default)
w Initial status for programming mode.
Day for SW Update
This setting specifies a day for starting the data transfer.
The default setting for the update to start is day 01.
Required: Programming mode must be activated (*95
31994).
dih w Enter the programming code.
de.ge Enter the day for starting the transfer.
w Initial status for programming mode.