Step by step
General settings
108
w Initial status for programming mode.
Updating the software
Sw information
This displays information about the system’s software.
To view this information use a system telephone with a
display.
The switch must be connected to a PC and the Com-
mServer and the APS Version Verifier must be running.
Required: Programming mode must be activated (*95
31994).
dde Enter the programming code to view the name of the
product, e.g., "HiPath 1150.
q w Press the key to view additional information:
1) Type of system;
2) Release;
3) Version;
4) APS;
5) Serial number;
r w Press this key.
Initial status for programming mode.
Local SW update
This feature initiates the download of the last software
version released for the PC and then downloads the up-
date for the exchange.
For this feature to work the system must be connected
to a PC with CommServer and APS Version Verifier run-
ning.
Required: Programming mode must be activated (*95
31994).
If 31 is entered, the Call Charge limit will be reset
to the last day of each month.
To Next Page
Loading...
