Step by step
Important settings
36
COS changeover
You can allow or deny a temporary COS changeover
from an extension to a different extension.
Required: Programming mode must be activated (*95
31994).
ekl w Enter the programming code.
p w Enter the extension number (e.g., 11/101).
q or r w To allow/deny COS changeover:
q = Allowed
r = Denied (default)
p w Enter the next extension number
or
r w Press this key.
Initial status for programming mode.
Attendant console
The attendant console centralizes the flow of calls at up
to two answering stations equipped with system tele-
phones with a display. In the default configuration no at-
tendant console is configured.
Required: Programming mode must be activated (*95
31994).
eid w Enter the programming code.
p w Enter an extension number for the attendant console
(e.g., 12/102).
p w Enter the next extension number, if you wish.
or
r w Press this key.
Initial status for programming mode.
Deleting an attendant console
Required: Programming mode must be activated (*95
31994).
eid w Enter the programming code.
q w Delete all attendant consoles.
To Next Page
Loading...
