Step by step
Programming an extension
72
p w Enter the next analog extension number
or
r w Press this key.
Initial status for programming mode.
Electronic lock password
This option allows you to set a 5-digit password to pro-
tect an extension against unauthorized use. When this
option is selected, only internal calls or Speed Dial calls
can be made from the extension. If the user of an ex-
tension forgets the password used to block the exten-
sion, the password can be reset to the system’s default
(default password is 0000).
Required: Programming mode must be activated (*95
31994).
efj w Enter the programming code.
p w Enter the extension number (e.g. 12/102).
p w Enter a 5-digit password to set an electronic lock for the
extension (default is 00000)
or
q Delete the electronic lock password (it defaults to
00000)
w Initial status for programming mode.
Timeout for call forward no answer
This feature specifies a timeout for the first attendant to
answer an incoming call. If the call is not answered, it is
forwarded to a second attendant, as programmed (see
call forward no answer in the User Manual).
To enable this feature, analog extensions must
be configured for CLIP.
A blocked extension can only make internal calls
using the system speed dialing phonebook (ab-
breviated numbers) if its class of service is not
changed (see Special class of service for a
blocked extension).
To Next Page
Loading...
