Siemens HiPath 1120 - Search Mode for Hunt Groups

Step by step
Programming an extension
66
r w Press this key.
Initial status for programming mode.
Deleting extensions from Hunt groups
Required: Programming mode must be activated (*95
31994).
dfe w Enter the programming code.
p w Enter the Hunt group number (780 to 789)
q w Delete all extensions in the Hunt group.
r w Press this key.
Initial status for programming mode.
Search Mode for Hunt groups
This setting specifies how each Hunt group will conduct
a search for an available extension: linear search or
round-robin search.
• A linear search always starts from the first extension
in the group
• A round-robin search starts after the last extension
selected
Required: Programming mode must be activated (*95
31994).
dff w Enter the programming code.
p w Enter the Hunt group number (780 to 789).
e or f w Select the search mode:
e = Linear (default)
f = Cyclical
p w Enter the next Hunt group number.
or
r w Press this key.
Initial status for programming mode.
This feature only works for digital lines.