Programming mode
17
Step by step
Programming mode
You can change the default settings of the HiPath 1100
to fit your needs. An MF-type or system telephone can
be used for this purpose, or a PC with the HiPath 1100
Manager administration software installed
(Æ page 186).
Numbering plan
The Numbering plan is configured based on the mod-
ules detected by the system.
• For the HiPath 1120:
1. Motherboard
2. S
0
module
3. Analog modules/UP
0/E
Module
• For the HiPath 1150:
1. TME1 module;
2. Motherboard
3. S
0
module
4. Analog modules/UP
0/E
Module
• For the HiPath 1190:
1. TME1 module;
2. Analog modules/UP
0/E
Module
3. S
0
module
The instructions that follow refer to the factory
default settings.
Description HiPath 1120 HiPath 1150 HiPath 1190
External line 801 to 808 801 to 832 801 to 845
Extension, including S
0
11 t o 30 11 t o 60
610 to 645
101 to 240
Groups of external lines 0 , 890 to 899
Call groups (CG) 770 to 779
Hunt groups (HG) 780 to 789
UCD subscriber groups 790 to 799
Carrier 9
EVM - Default internal number 790
EVM - Message ports 7491 and 7492
EVM - Virtual Ports 744 to 747
To Next Page
Loading...
