Siemens HiPath 1120 Programming Manual

Relay and sensor on the HiPath 1120
181
Step by step
Number dialed by sensor activation
This setting specifies the number to be automatically
called when a specific sensor is activated. The number
to be dialed when the sensor is activated is stored in
the system speed dialing phonebook in entry 249.
When the number stored in the system speed dialing is
changed, this field is updated. Similarly, when the num-
ber in the field is changed, the change is reflected in the
system speed dialing phonebook.
The default configuration does not specify any number.
Required: Programming mode must be activated (*95
31994).
dif w Enter the programming code.
p w Enter the number to be called (up to 20 digits).
w Initial status for programming mode.
Number of attempts for activating the sensor
This setting specifies the number of call attempts (be-
tween 1 and 100) for the number specified in "Number
dialed by sensor activation." (see also Time between at-
tempts for activating the sensor).
An attempt is made after every call that was not an-
swered (busy signal), or when the "Detect DTMF Code"
option (Code 70, Option 3) is activated and no acknowl-
edgment is received. When this occurs, the call is dis-
connected and a new attempt is made.
By default, only one attempt is made.
Required: Programming mode must be activated (*95
31994).
dig w Enter the programming code.
dde ... edd w Enter the number of attempts (001 to 100).
w Initial status for programming mode.

Siemens HiPath 1120 Specifications

General

Brand	Siemens
Model	HiPath 1120
Category	Telephone
Language	English