Programming an extension
57
Step by step
Deleting Extensions from a UCD subscriber group
Required: Programming mode must be activated (*95
31994).
dfg w Enter the programming code.
p w Enter the UCD subscriber group number (790 to 799).
q w Deletes all extensions in the UCD subscriber group.
r w Press this key.
Initial status for programming mode.
Collect call barring for a UCD subscriber
group
When this blocking is activated, the system automati-
cally rejects all incoming collect calls to a UCD group
over a digital line. Calls received over an analog line are
rejected only at the moment they are answered. The
system bypasses collect call barring for members and
non-members of the group. This means that collect call
barring is only acknowledged.
Required: Programming mode must be activated (*95
31994).
ddk w Enter the programming code.
p w Enter the UCD group number (e.g., 790).
q or r w Activate/Disable collect call barring.
q = Activate
r = Disable (default)
p w Enter the next UCD group number.
or
r w Press this key.
Initial status for programming mode.
If a call has been answered at least once by the
system, collect call barring cancels the blocking.
If an incoming call over a digital line is forwarded
because there was no answered (*14), and col-
lect call barring is activated, the call will ring at
the first attendant for the external line.
To Next Page
Loading...
