Siemens HiPath 1120 - Call Charge Factor for Extensions; Call Charge Value by Extension

Step by step
General settings
106
The default setting specifies that each pulse be multi-
plied by 1 for both factors.
Required: Programming mode must be activated (*95
31994).
dhf w Enter the programming code.
e or f w Select a call charge factor:
e = Factor 1
f = Factor 2
ddd . fih w Select a pulse multiplier.
w Initial status for programming mode.
Call charge factor for extensions
This setting specifies whether there is a factor for billing
the users.
Required: Programming mode must be activated (*95
31994).
dhg w Enter the programming code.
p w Enter the extension number (e.g. 11/101).
e.gw Select a billing factor for the extension:
e = Default - equivalent to the billing value x1 (default)
f = Factor 1
g = Factor 2
p w Enter the next extension number.
or
r w Press this key.
Initial status for programming mode.
Call charge value by extension
This setting specifies the monthly amount that each ex-
tension can spend.
The default value is the "0" comma slot and the "00001"
factor.
Required: Programming mode must be activated (*95
31994).