Report
137
Step by step
Call detail report for incoming calls
If the system is activated for Caller ID over digital (E1
CAS or S2 access) or analog lines activated by a local
carrier, the call information will be displayed on the call
detail report.
The "Ext" (Extensions), "Ring" (Ring Duration), "Duration"
(Call Duration) and "Call fees" (Pulses) columns remain
empty while the "I" (Type of Call) column shows an "
*
"
next to the call.
Required: Programming mode must be activated (*95
31994).
eje w Enter the programming code.
e.h Enter the code for the type of call detail report.
e = Outgoing calls are recorded at the end of the call.
Incoming calls (with or without Caller ID at the
source) are recorded at the end of the call
(default).
f = Outgoing calls are recorded at the end of the call.
g = Outgoing calls are recorded at the end of the call.
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
Incoming calls (with or without Caller ID at the
source) are recorded at the end of the call.
h = Outgoing calls are recorded at the end of the call.
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
w Initial status for programming mode.
Call detail report filter
The number programmed in this filter specifies the type
of outgoing call to be recorded, based on the first four
digits of the dialed number.
For example, In order to record only outgoing interna-
tional calls you must program the digits "00".
The maximum number of digits is 4.
Caller ID service must be contracted with a local
carrier.
To Next Page
Loading...
