Programming an extension
73
Step by step
Required: Programming mode must be activated (*95
31994).
egd w Enter the programming code.
de . mm Enter the length of time (01 to 99 in cycles of 5 seconds)
where 01 = 5 seconds... 06 = 30 seconds (default).
w Initial status for programming mode.
Conditional forwarding limited by ex-
tension
l
Incoming calls can be forwarded to a specified destina-
tion list, as configured in a TAPI-type application such as
a Windows TAPI Browser. The settings of the previous
list or unconditional call forwarding will be replaced with
the new list settings.
The following information is required for configuring a
list:
• Incoming caller ID
• Day of the week and time
• Type of call (internal or external)
When more than one number have been specified for
incoming calls to an extension, the call forwarding prior-
ity will be:
1. Checks to see if the Caller ID for the incoming call
matches the number programmed for the extension
2. Checks to ensure that the Type of Call (internal or ex-
ternal) has been configured
3. Checks the time settings.
Required: Programming mode must be activated (*95
31994). The extension has permission for a conditional
call forwarding.
dmk w Enter the programming code.
de . id Enter the number of digits that can be programmed for
extensions with permission (default is 5).
w Initial status for programming mode.
This configuration is available through a CTI inter-
face
To Next Page
Loading...
