Siemens HiPath 1120 - Dial Tone Detection

External line settings
49
Step by step
Dial tone detection
If Dial tone detection is activated on an analog line, the
number dialed will be stored and will only be sent to the
external line after the extension detects a dial tone from
the local carrier. If there is no dial tone on the line (line
not installed) the system automatically blocks this line.
With MF telephones, the number dialed will be trans-
mitted to the external line approximately 4 to 5 seconds
after the last digit was dialed (1A dialing).
Required: Programming mode must be activated (*95
31994).
ejd w Enter the programming code.
p w Enter a number for an analog trunk (e.g., 801).
q or r w Activate/Disable dial tone detection for an analog trunk:
q = Activate (default)
r = Disable
p w Enter the number for the next external line available.
or
r w Press this key.
Initial status for programming mode.