Programming an extension
63
Step by step
• Number 1 configured with unconditional call for-
warding to number 2 and with call forward no an-
swer to number 4, and number 2 configured with
unconditional call forwarding to number 3 and with
call forward no answer to number 5: a call to number
1 will be forwarded to number 3, and if number 3
does not answer, the call will be forwarded to num-
ber 4. Call forward no answer of number 2 will be ig-
nored.
Cascaded call forwarding partner
Cascaded call forwarding allows you to choose how the
call forwarding partner will be displayed on the tele-
phone display.
In the following situation: Number 1 is set to forward to
number 2 and number 2 is set to forward to number 3.
Here, the display can be configured as follows:
• Last partner: the caller display will show the follow-
ing: "forwarded to: number 3” and number 3 display
will indicate: "from: number 1.
• First partner: the caller display will show the follow-
ing: "forwarded to: number 2” and number 3 display
will indicate: "from: number 2".
Required: Programming mode must be activated (*95
31994).
ele w Enter the programming code.
d or e w Enter the code for the display mode:
d = Last (default)
e = First
w Initial status for programming mode.
If number 3 is a VMI:
• Last: The message is stored in number 1’s
mailbox. If number 1 does not have a mail-
box, the voice mail must request the port for
recording the message
• First: The message is stored in number 2’s
Mailbox.
To Next Page
Loading...
