Siemens HiPath 1120 - Coefficient for an Analog Trunk

External line settings
47
Step by step
eek
w Enter the programming code.
p w Enter a length of time (05 to 20 seconds).
w Initial status for programming mode.
Coefficient for an analog trunk
If the appropriate impedance value or type of external
line is available, the quality of transmission and recep-
tion of information between the local carrier and the
PABX can be improved.
Required: Programming mode must be activated (*95
31994).
ehk w Enter the programming code.
p w Enter a number for an analog trunk (e.g., 801).
e.hw Enter the appropriate number for the type of external
line:
For example, in the case of Brazil it would be:
e = standard 900 line Ω (default)
f = 600 line Ω
g = short line
h = long line
p w Enter the next external line number.
or
r w Press this key.
Initial status for programming mode.
Default:
• 13 seconds for Argentina,
• 04 seconds for Korea and
• 06 seconds for all other countries.