Step by step
Important settings
40
Time for LCR fallback
This configures the routing time to the default carrier
defined in that rule of the LCR (See Manager - A31003-
K1160-M810-*, LCR).
Required: Programming mode must be activated (*95
31994).
fiew Enter the programming code.
di ... gd Enter the time for the exchange (from 05 to 30 sec-
onds). Default is 05 seconds.
w Initial status for programming mode.
ACS (Alternative carrier selection)
If the system is programmed with the ACS (Alternative
carrier selection) option, you may define in the system
which route/destination the call should follow, indepen-
dently of the one selected by the user. This feature is
useful for choosing the route/destination with the
best rate when he call is actually made or for setting a
single route, once the conversion rules are duly pro-
grammed.
The first digits of the number dialed by the user are an-
alyzed by the system. If they match the conversion rule,
they will be replaced by the default number as set forth
by that rule. The route/destination to be used can also
be predetermined. There is no field available to specify
a carrier. The carrier code must be included in the con-
version rule.
Different conversion rules can be applied to the same
number, depending on the time of day and day of the
week. It is possible to define a maximum of 100 conver-
sion rules.
Example: Number dialed: 262 XXXX
Conversion Rules:
When a rule uses the overflow option, it may or
may not change the dialing rule.
To Next Page
Loading...
