Digital trunk settings
155
Step by step
ISDN Layer 1
Allows you to change some default ISDN settings for
specified countries.
Required: Programming mode must be activated (*95
31994).
ede w Enter the programming code.
de, df, Enter the S
0
module slot on the system
1
.
dg or ee
p
Enter the slot for the S
0
module slot:
dd . de = For the HiPath 1120 (The slot for
port 00 is only used for the external line - PP or PMP);
dd . dh = For the HiPath 1150;
dd . dh= For the HiPath 1190 (For the second
module, place position 11 and port from 00 ... 04).
q or r w Activate/deactivate layer
q = Activated
r = Deactivated
w Initial status for programming mode.
When there is an incoming call to an extension
activated for external call forwarding, the system
sends information about the call’s new destina-
tion and the number of the forwarded extension
to the public network. This is done by means of
a call deflection activation message. The call is
forwarded over the public network, which means
that on theHiPath 1100, B channels are not need-
ed.
The local carrier can send to the HiPath 1100 in-
formation about the forwarded call billing.
If external call forwarding cannot be carried out
through Call Deflection to the public network, it
will be carried out by the system.
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
To Next Page
Loading...
