Siemens HiPath 1120 - Remote Administration Password through an MSN; Delete Disconnected Consoles

General settings
123
Step by step
This setting specifies how the MSN is shown on a sys-
tem telephone display. In the default configuration no
Mode is configured.
Required: Programming mode must be activated (*95
31994).
ffh w Enter the programming code.
d.fw Select the information to be shown on the display:
d = None (default)
e = MSN name
f = MSN number
w Initial status for programming mode.
Remote administration password
through an MSN
This setting allows you to specify a password so that all
incoming calls from a remote HiPath 1100 Manager that
provides the correct password can be authorized to ex-
ecute remote administration. In the default configura-
tion, no password is set.
Required: Programming mode must be activated (*95
31994).
ffd w Enter the programming code.
p w Enter an access code consisting of a maximum of 5 dig-
its.
w Initial status for programming mode.
Delete disconnected consoles
This feature does not work when option 1 is se-
lected in the programming of code 039Caller ID
by name/number.
In order to enable this feature the Without MSN
verification function (Code 070) must also be ac-
tivated.