Step by step
General settings
124
This programming code should be used in case the
warning message "NBR. MAX. KEY DIAL EXCED" is
shown on the display when connecting a console (opti-
Point key module or optiPoint BLF) to an optiPoint 500
telephone set or enabling a virtual keypad (See User
Manual - A31003-K1160-B802-*-* ) on the system tele-
phone (KS).
Required: Programming mode must be activated (*95
31994).
ejj w Enter the programming code.
w Initial status for programming mode.
If this code is used, all the programmed keys of
the disconnected consoles will be lost.
To Next Page
Loading...
