Setup and Installation
226
TME1 module
The TME1 module can only be installed in slot 3 (Æ page 219).
U
P0/E
Module
The HiPath 1150 the U
P0/E
module can only be installed in Slot 1 or 2. In
order to use a U
P0/E
module you must install a CTR-U
P0/E
module on the
MB (Æ page 219).
Warning: Do not touch the administration serial interface connector
of the TME1 module before disconnecting all analog extensions and
external line connectors. Failure to follow this procedure may ex-
pose the user to dangerous voltages. The TME1 module intercon-
necting cables and connectors should only be handled by qualified
technical personnel.
To Next Page
Loading...
