Step by step
Entrance telephone
126
Entrance telephone
The HiPath 1100 can be connected to 2 different types
of entrance telephone:
• The internal entrance telephone, which uses a con-
nection interface between the door device and the
PABX (for example, TFE)
• The external door extension, connected directly to
the A/B or S
0
slot
Internal entrance telephone
Configuring an internal entrance telephone
This function enables the system to use an entrance
telephone. You can connect up to 20 entrance tele-
phones in extension slots. Each entrance telephone
must be individually activated in the system.
Required: Programming mode must be activated (*95
31994).
eei w Enter the programming code.
e.fdw Select a slot for the entrance telephone extension (1 to
20).
p w Enter the analog extension number (e.g., 12/102) to be
activated as an entrance telephone.
p w Repeat these steps for any additional slot.
or
r w Press this key.
Initial status for programming mode.
Deleting an entrance telephone assignment
Required: Programming mode must be activated (*95
31994).
eei w Enter the programming code.
e.fdw Enter the slot to be deleted.
q w Delete the assignment of the entrance telephone to the
extension.
p w Enter the next slot.
or
To Next Page
Loading...
