Programming an extension
91
Step by step
Modem extension
This setting specifies the extension where the modem
will be connected for serial remote access.
By default, no extension is configured.
Required: Programming mode must be activated (*95
31994).
dli w Enter the programming code.
p w Enter the extension number (e.g. 11/101).
w Initial status for programming mode.
External-to-external transfer
This feature allows a specified extension to transfer an
external call (incoming or outgoing) to another external
call.
Required: Programming mode must be activated (*95
31994).
dme w Enter the programming code.
p w Enter the extension number (e.g. 11/101).
q or r w Activate/deactivate transfer:
q = Activated
r = Deactivated (default)
r w Press this key.
Initial status for programming mode.
An external-to-external transfer can only be
made when at least one of the lines is a digital
line and one of the calls is outgoing.
An external-to-external transfer over an analog
line is terminated in the following three situa-
tions:
• Elapsed timeout for external-to-external con-
nection (Code 218)
• When a busy signal is detected
• Type of answering signal (Code 158).
To Next Page
Loading...
Need help?
General