Programming an extension
87
Step by step
Timer for outgoing external calls
This setting specifies a maximum time for the duration
of an outgoing external call for each extension.
The time count starts upon connection of a call and it
never restarts while the call is in progress (e.g., when
there is a transfer). Once the time expires, the call is ter-
minated.
In the default configuration the maximum time for the
duration of outgoing external calls is 180 seconds for all
extensions.
Required: Programming mode must be activated (*95
31994).
dhk w Enter the programming code.
p w Enter the extension number (e.g. 11/101).
p w Enter the length of time for the duration of external calls
for the specified extension (00000 to 17280 in 5-second
cycles), where 00 = 0 seconds... 36 = 180 seconds (de-
fault), etc.
p w Enter the next extension number.
or
r w Press this key.
Initial status for programming mode.
Activate/Disable timer for outgoing external
calls
Required: Programming mode must be activated (*95
31994).
dhl w Enter the programming code.
p w Enter the extension number (e.g. 11/101).
q or r w Activate/Disable the timer for an outgoing external call:
q = Activated
r = Deactivated (default)
w Initial status for programming mode.
Timeout for external calls
To Next Page
Loading...
