Step by step
Programming an extension
76
The Dialing mode designates the dialing method as
pulse (DP), tone (DTMF) or automatic detection.
Required: Programming mode must be activated (*95
31994).
ejl w Enter the programming code.
p w Enter the extension number (e.g., 12/102).
d.fw Enter the code for the dialing mode:
d = Automatic identification (default)
e = Pulse (DP)
f = Multifrequency (MF)
p w Enter the next extension number
or
r w Press this key.
Initial status for programming mode.
Flash detection time
The Flash detection time is the maximum period of
time required by a PABX to detect a flash signal gener-
ated by an internal telephone. If older MF dialing tele-
phones are connected to the system, it may be neces-
sary to adjust the Flash detection time to their response
times (see manufacturer’s instructions). The specified
Flash detection time may vary for different countries.
Required: Programming mode must be activated (*95
31994).
ege w Enter the programming code.
p w Enter the extension number (e.g. 12/102).
dde . fid Enter the Flash detection time (001 to 250, in cycles of
10 ms). 001 = 10ms ... 010 = 100 ms ... 035 = 350 ms,
etc.
p w Enter the next extension number.
or
Default:
• 035 - Portugal, Argentina and Thailand
• 036 - for Korea
• 028 - for all other countries.
To Next Page
Loading...
