Siemens HiPath 1120 - DTMF Signals for the Sensor; Sensor Message

Step by step
Relay and sensor on the HiPath 1120
182
DTMF signals for the sensor
This setting specifies a number sequence that is con-
verted to DTMF signals and sent after a call is an-
swered. The number to be called must be specified in
"Number dialed by sensor activation" (Code 052).
The default configuration does not specify any number.
Required: Programming mode must be activated (*95
31994).
ekk w Enter the programming code.
p w Enter the number sequence (up to 20 digits).
r w Press this key.
Initial status for programming mode.
Sensor message
After assigning a number, you can assign a message to
the sensor. This message will be transmitted to the as-
signed number when the sensor status is changed.
Required: Programming mode is activated (*95 31994)
and an EVM Module is installed.
feg w Enter the programming code.
e or f Select a Message:
e = Greeting 1
f = Greeting 2
w Initial status for programming mode.