Entrance telephone
129
Step by step
q
w Delete extensions activated for opening doors.
r w Press this key.
Initial status for programming mode.
Deleting Authorized Extensions
Required: Programming mode must be activated (*95
31994).
efi w Enter the programming code.
e.fd w Enter the slot for the extension configured as the door
opener (1 to 20).
q w Delete the extension assigned to the entrance tele-
phone slot.
r w Press this key.
Initial status for programming mode.
External door extension
The use of an external door extension is defined during
the programming phase of ”Type of equipment con-
nected to the extension” Æ page 85, code 003. These
devices are connected directly to analog ports A/B or in
the bar of the S
0
module as follows:
• The external analog entrance telephone device
must behave like an analog telephone (dialing, de-
tection and DTMF control)
• The ISDN external door extension device must be-
have like an ISDN telephone. It must also be con-
trolled by DTMF signals.
Consult the external door extension manual to
check available settings.
Go to the HiPath 1100 Manager folder - Ad-
vanced/System Settings/General - "External en-
trance telephone" and enter the information on
the entrance telephone device for the device to
work correctly.
To Next Page
Loading...
