Step by step
General settings
116
dd = Recognizes all slots (default)
de a fd = Recognizes the specific slot
r w Press this key.
Initial status for programming mode.
When the "00" option is selected, the system detects
the components as described on Æ page 17.
This means that if a numbering sequence for analog
lines/extensions has previously been configured, it will
be changed when an S
0
Module or a TME1 Module is
added.
Example 1: In a HiPath 1150 system that has only an
MB Module (2 external lines and 10 analog extensions)
the numbering pattern will be 801 and 802 for analog
trunks, and from 11 to 20 for analog extensions. When
a S
0
is added you have:
- 803 to 806 for the digital lines
- 21 to 25 for S
0
extensions
Example 2: for a HiPath 1190 system:
MB + EB 210 + S
0
- 5 ports
801 to 802 - analog trunks
101 to 110 - analog extensions
803 to 812 - S
0
digital lines
111 to 115 - S
0
extensions
If a specific slot is selected (01 to 20), the previous num-
bering will be maintained and the system will only de-
tect the module.
Remote administration
Service call
This feature allows you to call a service center and let
administration be carried out remotely, through the call
established.
qmmh Enter this code.
The modules can only be connected/disconnect-
ed when the system is turned off.
To Next Page
Loading...
