Step by step
Programming an extension
86
or
r w Press this key.
Initial status for programming mode.
Pulses for call charges on an analog ex-
tension
This sends pulses to be charged for calls on an analog
extension (12kHz/16kHz). With this feature, an exten-
sion’s telephone set can display the number of pulses
or the amount charged for the call.
Required: Telephone with a display and programming
mode activated (*95 31994).
dhe w Enter the programming code.
p w Enter the analog extension number (e.g., 11/101).
q or r w Activate/Disable transmission of billing pulses:
q = Activated
r = Deactivated (default)
p w Enter the next analog extension number.
or
r w Press this key.
Initial status for programming mode.
If the telephone does not have a microphone
(e.g. analog telephones, optiPoint Entry and Ba-
sic) the subscriber hears a busy signal when pro-
gramming the code.
Please refer to the documentation provided with
the telephone set connected to the extension to
find out if a billing indication is supported and
which transmission mode is used.
To Next Page
Loading...
