Siemens HiPath 1120 - MSN Answering for Fax;DID; Fax Extension for MSN

Step by step
Fax/DID
146
MSN Answering for Fax/DID
This setting specifies a Fax/DID answering mode for
each MSN number.
Required: Programming mode must be activated (*95
31994).
dld w Enter the programming code.
dde ... ehd w Enter MSN slot (001 ... 140).
d ... i Select an answering mode for MSN:
d = deactivated (default)
e = Fax
f = Attendant
g = Fax/DID
h = Greeting (message)
i = Auto-Fax
p w Enter next MSN.
or
r w Press this key.
Initial status for programming mode.
Fax extension for MSN
After detecting a fax signal, the Fax/DID module can
transfer a call to a Fax extension. The DID Mode does
not need to be configured for this feature.
Required: Programming mode must be activated (*95
31994).
dle w Enter the programming code.
dde ... ehd w Enter MSN slot (001 ... 140).
p w Enter the extension number for Fax Reception (e.g., 12/
102).
dde ... ehd w Enter the next MSN position.
In this case, the ""Call deflection" on page. 154"
feature (Code 228) does not work.