Siemens HiPath 1120 - Sensor Function Configuration; Sensor Activation Logic

Relay and sensor on the HiPath 1120
179
Step by step
Sensor function configuration
Required: Programming mode must be activated (*95
31994).
ekd w Enter the programming code.
d ... g Select the sensor’s function:
d = Deactivate the sensor function (default)
e = Dial the number specified in "Number dialed by
sensor activation" (Code 052).
f = Enable the relay through the sensor
g = Detect DTMF code. When this setting is select-
ed, the number that was called must acknowl-
edge or ignore an alarm call by sending an
acknowledgement code (“#” DTMF signal)
r w Press this key.
Initial status for programming mode.
Sensor activation logic
The main position of the sensor can be set as follows:
• Contacts are closed. The sensor is activated when
contacts are open
• Contacts are open. The sensor is activated when
contacts are closed
Required: Programming mode must be activated (*95
31994).
ekh w Enter the programming code.
d or e w Select the main position for the sensor:
d = Contacts closed (default)
e = Contacts open
r w Press this key.
Initial status for programming mode.