Siemens HiPath 1120 - No DIV.LEG Info for ISDN Line

Digital trunk settings
157
Step by step
dd
. dh = For the HiPath 1150
dd . dh = For theHiPath 1190 (For the second
module, place position 11 and port from 00 ... 04).
q or r w Master/Slave.
q = Master
r = Slave
w Initial status for programming mode.
"No DIV.LEG info" for ISDN line
If this option is deactivated and a local carrier provides
the "Diversion" service for ISDN lines, the extension
forwarding the external calls to an external line can
show the original numbers of the participants to the
calling parties.
Otherwise, only the number of the MSN/Attendant of
the PABX will be made available.
In the default configuration, this option is activated for
the following countries: Australia, Greece and the Neth-
erlands.
Required: Programming mode must be activated (*95
31994).
fhm w Enter the programming code.
p Enter the S
0
module slot on the system.
df = For the HiPath 1120
dg = For the HiPath 1150;
de and ee = For the HiPath 1190 .
p Enter the slot for the S
0
module port:
dd . de = For the HiPath 1120 (The slot for
port 00 is only used for the external line - PP or PMP)
dd . dh = For the HiPath 1150;
dd . dh = For theHiPath 1190 (For the second
module, place position 11 and port from 00 ... 04).
q or r w Activate/Deactivate.
q = Activate
r = Deactivate