Programming an extension
81
Step by step
de
a dl= for the HiPath 1150
de a fh= for the HiPath 1190
p w Enter the extension number (e.g. 12/102) to which you
want to assign the CD port.
p w Enter the next number for the CD port and extension.
or
r w Press this key.
Initial status for programming mode.
Deleting a CD Assignment from an Extension
Required: Programming mode must be activated (*95
31994).
ehj w Enter the programming code.
p w Enter a number from 01 to 24 for the CD port.
p w Enter the extension number (e.g. 12/102) to be pro-
grammed.
q w Delete the CD assignment from the extension.
p w Enter the next number for the CD port and extension.
or
Rr w Press this key.
Initial status for programming mode.
Extension coefficient
If the impedance value or appropriate type of internal
line is available, the quality of transmission and recep-
tion can be improved.
Required: Programming mode must be activated (*95
31994).
ehl w Enter the programming code.
p w Enter the analog extension number (e.g., 12/102).
e.hw Enter the appropriate number for the type of line.
For example, in the case of Brazil it would be:
By default, the assignment starts at the first ex-
tension slot on // systems HiPath 1120/1150.
To Next Page
Loading...
