Siemens HiPath 1120 - Call Detail Report through Serial Interface

Step by step
Report
138
In the default setting a digit sequence is not configured.
Required: Programming mode must be activated (*95
31994).
ejk w Enter the programming code.
p Enter the sequence of digits (up to 4) for the numbers
to be recorded.
Wait 5 seconds
w Wait for a confirmation tone.
Initial status for programming mode.
Call detail report through serial inter-
face
This setting specifies whether call detail report will be
done through a serial interface or a modem.
Required: Programming mode must be activated (*95
31994).
ddj w Enter the programming code.
q or r w Activate/Deactivate call detail report through a serial in-
terface:
q = Activated
r = Deactivated (default)
w Initial status for programming mode.