Siemens HiPath 1120 - Page 131

Report
131
Step by step
– Interface answers:
• For Windows’ Hyper Terminal, the following setting
is required:
– Configure the CommSever for ADSL connection.
– Select the "Serial Printing" checkbox on the HiPath
1100 Manager, under Advanced -> System Set-
tings
– Set the Hyper Terminal in TCP/IP mode with the
IP of the ADSL expansion board (ADSL, SLIMC,
SADSLIM, LIMC or ADSLIM modules):
HiPath 1100 V6.0 - ADSL Module (Default IP
10.0.0.1) and the port (9366);
HiPath 1100 V7.0 - SLIMC, SADSLIM, LIMC or
ADSLIM modules (Default IP 192.168.254.253)
and the port (9366);
– Do not use a Serial or ADSL connection type
while using HyperTerminal. During ticketing, the
administration can be performed via USB connec-
tion, optiPoint, ISDN or analog modem.
– Tickets will only be shown after the end of the first
connection.
– Disconnect HyperTerminal to establish a serial or
ADSL connection to the HiPath 1100 Manager.
Command Description
\nend of tick-
ets\n
This answer will be sent by the
PABX to the Application interface
when no stored tickets are left to be
transmitted. This command can be
used as an indicator to end com-
mand "\nticket_start\n" when all
stored tickets have been sent.
\nprint_stopped
\n
This answer will be sent by the
PABX to the Application interface af-
ter receiving command
"\nticket_stop\n" to inform the user
that the connection with the applica-
tion can be closed without losing
the tickets.
To set up and use the Billing Application, please
refer to the appropriate product manual.