VMIe protocol
193
Step by step
3. Direct internal call from Extension 11 to Extension
15, forwarded to the VMIe group configured as sec-
ond attendant. ***4****11****15*1;
4. Incoming call over an analog trunk to Extension 11,
forwarded (*11) to the VMIe group:
***3**********11*3;
5. Incoming call over a digital line to Extension 11, for-
warded (*11) to the VMIe group:
***3**********11*4;
6. Incoming call over an external analog line to Exten-
sion 12, forwarded to the VMIe group configured as
second attendant. ***4**********12*3;
7. Incoming call over a digital line to Extension 12, for-
warded to the VMIe group configured as second at-
tendant. ***4**********12*4;
8. Direct internal call from Extension 1015 to Extension
1011, forwarded to the VMIe group (*11):
***3**1015**1011*1;
9. Direct internal call from Extension 10015 to Exten-
sion 10011, forwarded to the VMIe group configured
as second attendant. ***4*10015*10011*1.
Voice mail Protocol for the system:
The voice mail signals to indicate when there is a mes-
sage waiting at an extension’s mailbox. For this purpose
it uses a DTMF service code (*68) followed by the ex-
tension number. When a message is erased, a different
DTMF code (#68) is used to deactivate the signal at the
extension that belongs to the VMIe group. In the event
these codes are not supported by the voice mail Sys-
tem they can be re-programmed. Please check items "
Deenabling the Internal MWI #68" and "Activating the
Internal MWI Internal *68" in the HiPath 1100 System
Manager "System Settings - Service Code" folder.
Example:
1. The voice mail System indicates that Extension 13
has a message waiting in mailbox: *6813;
2. The voice mail System indicates that the mailbox for
Extension 12 is empty: #6812.
To Next Page
Loading...
