Important settings
25
Step by step
p
w ... p w Enter the extension numbers (e.g., 11/101) or call
groups that should signal when receiving calls from the
specified external line (up to 10 extensions or 1 group).
r w Press this key.
Initial status for programming mode.
To assign an extension as an attendant for different
lines, repeat the programming steps.
Deleting attendants for an external line
Required: Programming mode must be activated (*95
31994).
ehf w Enter the programming code.
p w Enter a number for an analog trunk (e.g., 801).
e ... h Select the period of the day for answering calls:
e =Day
f = Night
g = Day service, second attendant
h = Night service, second attendant
q w The selected line attendant will be deleted.
rw Press this key.
Initial status for programming mode.
If an extension is connected to a door opener de-
vice, the device cannot be configured as an at-
tendant.
Within a subscriber group an incoming call rings
at the first extension available, according to the
call distribution plan configured for the UCD sub-
scriber group.
When no first DID is configured, the call will be
forwarded to the Overflow extension. In the
event that an Overflow extension is not config-
ured, the call will end. In such cases no exten-
sion is signaled and the call cannot be captured.
Meanwhile, the system will continue to wait for
an available external line.
To Next Page
Loading...
