Siemens HiPath 1120 - Page 44

Step by step
External line settings
44
HiPath 1100 systems are capable of receiving Caller ID
information through FSK and DTMF protocols over ana-
log lines. This service must be activated by the local car-
rier.
The default setting depends on the country.
Required: Programming mode must be activated (*95
31994).
ddi w Enter the programming code.
w Enter a number for an analog trunk (e.g., 801).
d.g Select the type of protocol:
d = deactivated
e = DTMF1
f = DTMF2 (off hook)
g= FSK
p w Enter the next external line number.
or
r w Press this key.
Initial status for programming mode.
When a Country setting is specified ("Country/
group of countries" on page 20), the appropriate
protocol is automatically selected.
Country Protocol Code
Brazil, China, India, Peru, IM-Spain
and IM-English
DTMF1 1
Russia DTMF2
(off hook)
2
Other countries FSK 3