Rapidlab 1200 Operator’s Guide: System Configuration 8-33
02087462 Rev. V
Enabling Remote Viewing Automatically or Manually
Automatic remote viewing allows the remote user to connect to the local system
any time the local system is operational. Remote viewing is available to remote
users when the local system is restarted.
Manual remote viewing requires the local operator to decide when to allow
remote viewing. Remote viewing is unavailable to remote users when the local
system is restarted.
1. At the Setup screen, select Printer and Devices.
Select the down arrow and then select Remote Viewer.
At the Remote Viewer screen a Services column and a Configure column
display.
2. To enable remote viewing automatically, select
Automatic in the Configure
column.
To disable remote viewing, select
Manual in the Configure column.
Manual is the default setting.
3. Select
Continue.
To Next Page
Loading...
