8-34 Rapidlab 1200 Operator’s Guide: System Configuration
02087462 Rev. V
Enabling Remote Viewing Using the Remote Viewing Buttons in the Banner
1. Enable remote viewing by following the procedure in Enabling Remote Viewing‚
page 8-32.
The message Disconnect Remote User displays when remote viewing is enabled and a
remote user connects to the local system. The message displays in the top-left corner
of the banner and alternates, at 5second intervals, with the current system status text.
When Disconnect Remote User displays, a remote viewer is connected to the system
and can view and control the system.
The Disconnect Remote User button also functions as a touch screen button.
2. To disconnect the remote viewer, select
Disconnect Remote User.
The Disconnect Remote User message changes into Enable Remote Viewer message.
When the Enable Remote Viewer message displays, the remote user is disconnected
and cannot view or control the local system.
The Enable Remote Viewer message also functions as a touch screen button.
3. To enable remote viewing, select
Enable Remote Viewer.
When selected, the Enable Remote Viewer button ceases to display.
When a remote user connects to the local system after the Enable Remote Viewer
button is selected, the Disconnect Remote Viewer button displays.
As explained in step 2, selecting the Disconnect Remote Viewer button disconnects
the remote user and the Enable Remote Viewer button displays, and can be used to
enable a remote viewer.
To Next Page
Loading...
