Simplex 4100ES Installation Guide

4-9
Chapter 4 Networking
Step 2. Mounting Media Cards to the NIC
Overview The 4100-6014 Network Interface Card (NIC) uses media cards to connect to other NICs. This
section describes how the media cards are mounted onto NICs.
Media Card
Mounting
NICs connect to each other via the three types of media cards. The types of media cards in the
right and left ports are determined by the type of wiring that is being used across cards.
Connect P1 on the wired media card, or J1 on the modem or fiber media cards, to P5 (the left
port) on the NIC.
To connect a second media card to the same NIC, connect it as described above, but use P6 (the
right port) on the NIC. Note that any two types of media cards can be connected to the same
NIC.
Figure 4-7. Media Card Mounting
MEDIA CARDS
4100-6014 NETWORK
INTERFACE CARD
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P5)
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P6)
STANDOFFS FIT INTO HOLES

Simplex 4100ES Specifications

General

Type	Fire Alarm Control Panel
Display	LCD
Battery Backup	Yes
Model	4100ES
Manufacturer	Simplex
Communication Protocol	Optional Ethernet
Signaling Line Circuits (SLCs)	Up to 10
Notification Appliance Circuits (NACs)	Up to 10
Agency Listings	UL, FM, CSFM, MEA
Max Relay Circuits	20
Communication Ports	Ethernet
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity	Up to 93% RH, non-condensing