G-3
Appendix G
Earth Fault Searching from the Front Panel
Overview This section describes how to conduct an Earth Fault Search, from selecting the appropriate
access code to correcting the fault.
Access Level
Selection
The panel must be at the appropriate access level (1, 2, 3, or 4) in order to run diagnostics. To
get to the correct access level,
1. Press the Menu button. The following message comes up (press the Next or Previous
buttons, if necessary, to display it):
2. Press the Enter button. Now you are prompted to log in or log out.
3. Press the "1" key on the numeric keypad to log in, so that the passcode prompt comes up.
4. Enter the passcode and press the Enter button. ACCESS GRANTED displays briefly on the
LCD, and then the display goes back to:
You can now open the diagnostic menu as described in the next topic.
Starting the Earth
Fault Search
To start an Earth Fault Search,
1. If necessary, press the Menu button to access the menus.
2. Press the Previous or Next buttons until the diagnostic functions option appears:
3. Press the Enter button. Then press Next or Previous buttons until the Earth Fault Search
option appears:
Continued on next page
Press <NEXT> or <PREVIOUS> to scroll
Change Access Level?
1=Login 2=Logout
CURRENT ACCESS LEVEL = x
Enter a Passcode followed by <ENTER>
1=Login 2=Logout
CURRENT ACCESS LEVEL = y
Press <NEXT> or <PREVIOUS> to scroll
Diagnostic Functions?
Press <NEXT> or <PREVIOUS> to scroll
Earth Fault Search?
To Next Page
Loading...
Need help?
General
