Simplex 4100ES - Audio Options Alongside Compatible Equipment; Table K-3. Audio Options that May be Configured Alongside Compatible Equipment

To Next Page

To Previous Page

K-4

Appendix K Audio Equipment Compatible with 520 Hz Low Frequency Alarm

Compatible Audio Equipment (continued)

Audio Options

Alongside

Compatible

Equipment

The following equipment is not part of the signal path for the 520 Hz Low Frequency Alarm

signal and therefore may be used along side compatible components of the audio system.

Table K-3. Audio Options That May Be Configured Alongside Compatible Equipment

Notification Appliance Description Model Numbers

Auxiliary Audio Input Board 4100-1240

Audio Operator Interface Modules 4100-1252

4100-1253

4100-1254

4100-1255

Expansion Bay 4100-2300

Audio Expansion Bay Harness Kit 4100-2320

Constant Supervision Modules 4100-1259

4100-1260

Message Expansion Board 4100-1241

4100-1242

Main Page

Default Chapter3
- Cautions, Warnings, and Regulatory Information3
- Emissions Compliance, Radio Frequency Immunity, Safety and Agency Approvals4
- Environmental Operating Range5
- Listings and Approvals5
- Listings, Approvals, Codes, and Standards5
- Table of Contents7
- List of Figures17
Chapter 1 Introduction to the 4100ES Fire Alarm System21
- Introduction21
- In this Chapter21
- System Configurations22
  - Overview23
- Standalone Configuration23
  - System Design23
  - Figure 1-1. Standalone 4100ES System23
- MINIPLEX Configuration24
- Network Configuration26
- 4100ES Back Box Pids28
  - Overview29
- 4100ES Pids29
- 4100 Pids (Non-4100ES/4100U)41
Chapter 2 Installing FACP Components45
- In this Chapter45
- Introduction45
- Introduction to the FACP46
- SPS CPU Bay Overview47
- EPS CPU Bay Overview51
- FACP Operator Interface56
  - Figure 2-10. Operator Interface56
  - Figure 2-11. Flexible User Interface56
- FACP Expansion Bays57
- FACP Power Requirements58
- Step 2. Mounting the System Electronics62
- Step 3. Trim Kit Application (Optional)65
- Step 4. Mounting the Door66
- Step 5. Installing Motherboards into the CPU Bay69
- Step 6. Installing Modules into Expansion Bays70
  - Figure 2-28. Expansion Bay 4" X 5" Card Placement70
- Step 7. Interconnecting Modules and Bays75
- Step 8. Configuring Cards83
- Step 9. Installing and Removing Batteries85
  - Figure 2-40. Multi-Bay Battery Installation86
- Step 10. System Power up and Power down Procedures87
  - System Power up Procedure87
  - System Power down Procedure87
- The Terminal Block Utility Module88
  - Figure 2-41. Terminal Block Utility Module Mounting88
Chapter 3 Installing 4100ES MINIPLEX Components91
- Introduction91
- In this Chapter91
- Introduction to MINIPLEX Transponders92
- MINIPLEX System Guidelines97
  - Guidelines97
- Configuring Cards98
- Tic/Riser Mounting99
- Tic/Motherboard Interconnections100
  - Interconnections100
  - Figure 3-3. Transponder Cabinet Interconnections100
- RUI Wiring101
  - RUI/RUI+ Specifications101
- MINIPLEX Audio Wiring102
Chapter 4 Networking106
- Introduction to the 4100 Network Interface Card106
- Step 1. Configuring Network Cards111
  - Modem Media Card Jumper Settings112
  - Fiber Media Jumper Settings (746-109 Only)112
- Step 2. Mounting Media Cards to the NIC113
- Step 3. Mounting Network Cards114
  - Figure 4-8. Installing the Daughter Card114
- Step 4. Wiring Network Cards115
- Network Audio Wiring126
- Digital Audio PDI Termination Plug131
  - Overview131
  - Figure 4-22. Installing a Digital Audio PDI Termination Plug131
Chapter 5 The System Power Supply (SPS)133
- Introduction133
- In this Chapter133
- SPS Specifications134
  - Table 5-1. Input and Output Specifications134
  - Table 5-2. SPS Current Specifications135
- SPS Configuration136
  - Jumper Settings136
- SPS LED Indications137
  - Leds137
- Troubleshooting138
Chapter 6 4100ES SPS Field Wiring139
- Introduction139
- In this Chapter139
- General Field Wiring Guidelines140
- Power Supply Wiring Distances143
  - Table 6-1. Class a Wiring Distances143
  - Table 6-2. Class B Wiring Distances144
- SPS NAC Field Wiring Guidelines145
  - Guidelines145
- SPS NAC Wiring146
- SPS Idnet Field Wiring Guidelines148
  - Guidelines148
  - Figure 6-5. Loop Wiring as Shown148
- SPS Idnet Wiring149
- SPS Auxiliary Power Wiring151
- SPS Auxiliary Relay Wiring153
- EPS with Idnet156
Chapter 7 EPS with Idnet 2156
- EPS Specifications156
  - Figure 7-1. EPS Card Layout156
    - Card Specifications156
- EPS Configuration157
- EPS Idnet 2 Configuration159
- Connections160
- Troubleshooting161
  - Table 7-6. SLC Channel Trouble LED Codes162
  - Table 7-7. EPS Trouble Messages163
Chapter 8 EPS and Idnet 2 Wiring165
- Introduction165
- In this Chapter165
- EPS Wiring Overview166
  - Figure 8-1. Power-Limited Wiring Guidelines166
- EPS Class B IDNAC Wiring167
- EPS Wiring Tables169
- EPS Wiring to Devices171
- EPS Auxiliary Power Wiring173
- Idnet 2 Card Wiring174
Chapter 9 PC Software Connections177
- Introduction177
- In this Chapter177
- Software Modes178
- Ethernet Service Port and Serial Service Port180
Chapter 10 MNS/ECS Application181
Chapter 10 MNS/ECS Application182
- Application of 4100ES as a UL2572 Mass Notification System182
  - Priority of Signals183
  - Timing Equations184
- Programming and Configuration185
Appendix A the Device Configuration DIP Switch189
- Figure A-1. DIP Switch Swx189
  - Overview190
- The Service Port190
  - Table A-1. Card Addresses190
Chapter B Installing 4100 FACP Components (Non-4100ES/4100U191
- Introduction191
- In this Chapter191
- Introduction to Facps192
  - Figure B-1. Master Controller Bay (4100192
- Step 1. Mounting Back Boxes198
- Step 2. Mounting Electronics Bays to Back Boxes200
- Step 3. Configuring Modules204
  - Master Controller Configuration205
  - Table B-4. UPS SW1 Battery Configurations205
- Step 4. Interconnecting Master Controller Bay Cards207
- Step 5. Installing Motherboards into Expansion Bays208
- Introduction to MINIPLEX Systems212
  - Figure C-1. MINIPLEX System Design213
    - Overview214
- MINIPLEX System Components214
- MINIPLEX System Guidelines216
  - Guidelines216
  - Figure C-4. Installing the RUI Motherboard in the CPU Bay217
- Installing Modules into Back Boxes217
  - Figure C-5. Installing the RIC II Motherboard into a 4100 Expansion Bay218
Appendix D Checking System Wiring223
- Overview223
- Using the Volt/Ohm Meter223
- Checking System Wiring223
Appendix E References to 4100ES Module Installation Instructions231
Appendix F Labels233
Appendix G Earth Fault Diagnostics235
- General Guidelines235
- Earth Fault Searching from the Front Panel237
- Search Results240
  - Fault Not Found241
- Earth Fault Search Example242
  - Figure G-1. Earth Fault Example242
Appendix H Special Application NAC-Compatible Notification Appliances and Accessories245
- Table H-1. Special Application NAC-Compatible Notification Appliances and Accessories246
Appendix Ieps Compatible Appliances and Devices249
- EPS Compatible Devices249
- EPS Compatible Appliances249
- Table I-1. Compatible Devices249
- Table I-2. Compatible Appliances249
Appendix J Cooper Wheelock Appliances Compatible with 4100ES Wheelock Protocol for Special Applications251
- Overview251
- Synchronizing Horn Strobes251
- Table J-1. Synchronizing Horn Strobes251
  - Synchronizing Strobes252
- Table J-2. Synchronizing Strobes252
  - Appliances with Synchronizing Strobes253
- Table J-3. Appliances with Synchronizing Strobes253
  - Synchronizing Horns254
- Table J-4. Synchronizing Horns254
  - Coded Audible Appliances255
  - Non-Synchronizing Appliances255
- Table J-5. Coded Audible Appliances255
- Table J-6. Non-Synchronizing Appliances255
Appendix K Audio Equipment Compatible with 520 Hz Low Frequency Alarm257
- Overview257
- Compatible Audio System Components257
- Table K-1. Compatible Audio System Components257
  - Compatible Notification Appliances258
- Table K-2. Compatible Notification Appliances259
  - Audio Options Alongside Compatible Equipment260
- Table K-3. Audio Options that May be Configured Alongside Compatible Equipment260

Simplex 4100ES - Audio Options Alongside Compatible Equipment; Table K-3. Audio Options that May be Configured Alongside Compatible Equipment

Table of Contents

Other manuals for Simplex 4100ES

Related product manuals