2-18
Chapter 2 Installing FACP Components
Step 2. Mounting the System Electronics
Overview This section describes the process for removing the CPU and equipment bays that come with
the system modules from their shipping container and installing them into the mounted back
boxes.
Mounting guidelines:
• The CPU bay must be installed in the top bay of the enclosure.
• Expansion bays mount in any bay area within an enclosure.
• Expansion bays mount in a 19” E.I.A rack console using an adapter kit.
Mounting the
System Electronics
Bays
Perform the following procedure to install the system electronics bays:
1. Disconnect the 734-008 Harness from P1 on the Power Distribution Interface (PDI).
2. Remove everything from the electronics shipping container, and set the screws aside.
3. Remove the shipping studs that secure the bays to the shipping container.
Figure 2-16. Removing the Shipping Studs
Continued on the next page
To Next Page
Loading...
