Simplex 4100ES - Installing Motherboards into a 4100 ES Expansion Bay; Figure 2-32. Installing the Motherboard in a 4100 ES Expansion Bay

2-30
Chapter 2 Installing FACP Components
Step 6. Installing Modules into Expansion Bays (continued)
Installing
Motherboards
into a 4100ES
Expansion Bay
Use the following procedure when installing motherboards in an expansion bay. Start with the
second slot from the left and fill to the right.
1. Orient the motherboard with the connector labeled J1 on the right and the header labeled P1
on the left.
2. Attach four metal threaded standoffs and lockwashers into the screw holes on the chassis.
3. Attach two grey plastic standoffs to the motherboard socket mounting screws.
4. Secure the motherboard to the standoffs using four #6 torx screws as shown below.
Figure 2-32. Installing the Motherboard in a 4100ES Expansion Bay
#6 SCREWS
LOCKWASHERS
METAL
STANDOFFS
SCREW HOLES
SCREW HOLES
PLASTIC STANDOFFS