RM0440 Rev 4 1315/2126
RM0440 General-purpose timers (TIM2/TIM3/TIM4/TIM5)
1343
Bit 21 DIRF: Direction change interrupt flag
This flag is set by hardware when the direction changes in encoder mode (DIR bit value in
TIMx_CR is changing). It is cleared by software by writing it to ‘0’.
0: No direction change
1: Direction change
Bit 20 IDXF: Index interrupt flag
This flag is set by hardware when an index event is detected. It is cleared by software by
writing it to ‘0’.
0: No index event occurred.
1: An index event has occurred
Bits 19:13 Reserved, must be kept at reset value.
Bit 12 CC4OF: Capture/Compare 4 overcapture flag
refer to CC1OF description
Bit 11 CC3OF: Capture/Compare 3 overcapture flag
refer to CC1OF description
Bit 10 CC2OF: Capture/compare 2 overcapture flag
refer to CC1OF description
Bit 9 CC1OF: Capture/Compare 1 overcapture flag
This flag is set by hardware only when the corresponding channel is configured in input
capture mode. It is cleared by software by writing it to ‘0’.
0: No overcapture has been detected.
1: The counter value has been captured in TIMx_CCR1 register while CC1IF flag was
already set
Bits 8:7 Reserved, must be kept at reset value.
Bit 6 TIF: Trigger interrupt flag
This flag is set by hardware on the TRG trigger event (active edge detected on tim_trgi input
when the slave mode controller is enabled in all modes but gated mode. It is set when the
counter starts or stops when gated mode is selected. It is cleared by software.
0: No trigger event occurred.
1: Trigger interrupt pending.
Bit 5 Reserved, must be kept at reset value.
Bit 4 CC4IF: Capture/Compare 4 interrupt flag
Refer to CC1IF description
Bit 3 CC3IF: Capture/Compare 3 interrupt flag
Refer to CC1IF description
To Next Page
Loading...
Need help?
General
