113
4 Adjusting knitting machine
4.1 Basic settings
Kb Correction value for the yarn carrier (on
the right) if the autarkic yarn carrier is
positioned in its own color field.
Minimum value: -120
Maximum value: 120
Step width:
0.5=1/32 inch=0.8 mm
K<I>a Correction value for yarn carrier (on the
left) if the autarkic yarn carrier is
positioned outside its own color field.
Minimum value: -120
Maximum value: 120
Step width:
0.5=1/32 inch=0.8 mm
K<I>b Correction value for yarn carrier (on the
right) if the autarkic yarn carrier is
positioned outside its own color field.
Minimum value: -120
Maximum value: 120
Step width:
0.5=1/32 inch=0.8 mm
mm] Correction of insertion position for
autarkic yarn carriers (ADF)
Positive value: following yarn carrier
Negative value: leading yarn carrier
Minimum value: -100
Maximum value: 100
Step width: 0,1 mm
mm] Correction of the insertion angle for
autarkic yarn carriers (ADF)
Positive value: Steeper yarn angle
Negative value: Flatter yarn angle
Minimum value: -2.5
Maximum value: 5.0
Step width: 0,1 mm
MSEC Carriage speed if this yarn carrier is used
(technical fabrics).
V Reduce carriage speed (n) for yarn
carrier (n = 0..3). The speed is reduced to
75% from carriage reversal point until
achievement of the operating range of
the yarn carrier. Finally it can be chosen
between the following possibilities:
1 = Acceleration up to 100%
2 = Braking down to 50%, maintain
speed over a fabric width of 2 inches,
acceleration up to 100%
3 = Braking down to 50%, maintain
speed over a fabric width of 5 inches,
acceleration up to 100%
0 = Cancelling out of carriage speed
specific to yarn carrier
Comment Comment ASCII Characters
Explanation Value range
To Next Page
Loading...
