161
4 Adjusting knitting machine
4.2 Advanced adjustments
4. Compare the displayed values with the values on the machine data
sheet. If necessary, correct the values on the machine data sheet (see
the "Copy Mc" description [ 158]).
5. Switch back to the previous window.
6. Call up the "Needle bed parameters" window.
7. Compare the displayed values with the values on the machine data
sheet. If necessary, correct the values on the machine data sheet.
8. Switch back to the previous window.
9. Call up the "NPK values" window.
10. Compare the displayed values with the values on the machine data
sheet. If necessary, correct the values on the machine data sheet.
11. Switch back to the previous window.
12. Call up the "Needle selection" window.
13. Compare the displayed values with the values on the machine data
sheet. If necessary, correct the values on the machine data sheet.
14. Call up "Main menu".
Carry out the reference run 1. If the racking device is not in the home position, press off the stitches of
a needle bed.
2. Call up the "Service" menu.
3. Call up the "Reference runs" window.
4. If the carriage assembly is stopped in the left reversing position, tap the
"SR!>" key.
- or -
➜ If the carriage assembly is stopped in the right reversing position, tap
the "SR!<" key.
5. Start the machine with the engaging rod.
The carriage assembly carries out a reference run and stops after
having loaded the reference data.
6. Press the engaging rod downward.
Reference run with older machines (before August
2013):
The carriage moves automatically in both directions
During the reference run, the carriage can move
independently into both directions.
The carriage stops automatically as soon as the reference
data is determined. The engaging rod falls down.
To Next Page
Loading...
